Does anyone have any recommendations on how to get my EMS speakers to stop buzzing?
My friend saw the ACME Speakers in Canadian Tire? Do you supply your product there?
How to get cables for EMS900 speakers?
Don'f forget the Connections info:
Input Connections Microphone Connections These inputs are for two low-impedance balanced dynamic microphones. Connect cable shield to center screw marked "GND." Auxiliary The AUX inputs provide unbalanced RCA inputs for connection to external signal-level equipment. AUX Muting For this function, a customer-supplied, normally-open contact closure (switch) must be connected to the AUX2 and MUTE terminals. When the contacts are closed, the AUX2 input will be muted. Typically activated by a switch in a push-to-talk style microphone. AUX 1, if selected, is not mutable by contact closure. TEL Connect the telephone line to the two outside terminals and the shield, if used, to the center terminal. TEL input signal will trigger automatic muting of AUX 1 and AUX 2. Input impedance is 600-ohm and is transformer balanced. Input is for "Dry" audio signals only, no DC voltage on the signal. Output Connections Speakers, General The amplifier may be used with most conventional speaker systems. Connect one speaker lead to the screw terminal that corresponds to the impedance of the type of speakers used in the system and the other lead to the COM terminal. If the line is shielded, connect the shield to GND. Connecting the GND to the COM terminal when using the transformer-coupled outputs references the transformer output to ground. Disconnecting the GND terminal from COM allows the transformer output to float electrically. This is sometimes useful under certain conditions where a ground connection is undesirable. It is generally a good idea to short the GND to the